Conmix ReCon PH

Single Component cementitious fairing coat and pin hole fillerConmix Recon PH is a one part, Polymer modified, cementitious thin fairing coat repair mortar for concrete surface, plaster surface, etc.

USES

Dusk Technology, Conmix ReCon PH is used to cover minor surface defects on concrete, plaster, mortar and stone masonry. As a cosmetic repair material it is used to eliminate small defects, pin holes and surface blemishes. It is suitable for small repairs to precast concrete elements, columns, beams and fair faced concrete.

ADVANTAGES:

• Good mechanical strength
• Single part, only add water
• Excellent bond to substrate
• Suitable for use in contact with potable water
• Chloride free
• Fast strength development
• Water curing is not required
• Can be over coated
• TYPICAL PROPERTIES at 25°C with W/P ratio at 0.24

SURFACE PREPARATION

Ensure that the surface is clean, free from laitance, traces of curing compounds, shuttering oil, grease, etc., which may hamper bond properties. No loose particles should be present. The surface must be saturated with water thoroughly for at least 2-4 hours before application of Dusk Technology  Conmix ReCon PH.MIXINGUse 5 to 6 ltrs of water for every 25 kg bag depending on consistency required. Mix using a slow speed heavy duty drill machine fitted with a paddle. Mix for approximately 3 minutes till a uniform mixed consistency is obtained. Part mixing can be adopted provided correct water to powder ratio is maintained.APPLICATIONMixed material is applied on the prepared surface using a steel trowel. It should be worked well into the pin holes and surface blemishes. It should be allowed to set partially before final finishing with sponge or steel trowel. Water can be sprinkled on the applied material before final trowel or sponging.APPLICATION THICKNESS: 1 mm up to 5 mm can be applied in one layerCOVERAGE: 16 m²/25 kg bag at 1 mm thicknessLIMITATIONSSetting time and strength gain will be affected by ambient conditions. Maximum thickness in single layer should not be more than 5 mm. Not to be applied if there is running water during application or before setting of material.Coverage: 16 m2 /25 kg bag at 1mm thickness. Packaging: 25 Kg bagFacebook page visit